Fire Marshal Issues Christmas Tree & Lighting Safety Tips

State Fire MarshalPrint Story | Email Story

STOW, Mass. — The state fire marshal is offering tips for enjoying your Christmas tree and other holiday decorations safely this season.

"The best way to prevent a Christmas tree fire is to water it well every day, use electric lights safely, and dispose of it soon after the holiday," said state Fire Marshal Stephen D. Coan.

Although Christmas tree fires are not common, when they do occur, they are more likely to be serious. In the United States, on average, one of every 40 reported home structure Christmas tree fires results in a death compared to an average of one death per 142 total reported home structure fires.

Fortunately, there were no Christmas tree fires in Massachusetts last year.

According to the U.S. Fire Administration, one of every three home Christmas tree fires are caused by electrical problems and a heat source too close to the tree caused roughly one in every six.

Selecting a Tree

Buy a cut tree as fresh as possible. Tap the butt on the ground and grab a branch near the top and pull your hand along it slowly. Needles should not fall off. If you bend a needle and it breaks before bending in half, it's too dry. If you use an artificial tree, select one with a flame-retardant label.

Caring for the Tree

Make a fresh cut an inch or two off the bottom before placing it in the stand. This will help with absorption. Water a live tree every day.


Placing the Tree

Place your tree in a non-tip style holder with wide feet, using extra wires if needed to keep it steady. Keep doorways and exits clear. Place your tree and decorations away from heaters, fireplaces, candles and other sources of heat.

Decorating the Tree

Purchase electric holiday lights that are listed by an approved testing agency and follow the manufacturer's directions. Consider switching to new LED lights that are cooler and use less electricity. Make sure the bulbs themselves are not touching the tree, curtains, wrapped gifts and tree skirts. Never use lighted candles as decorations. Turn off the lights when leaving the house or going to bed for the night. If you use an artificial tree, do not use electric lights on metal trees.

This video from the National Fire Protection Association shows how fast a dry tree can burn compared to a well-watered one.

Disposing of the Tree

Remove your tree soon after the holidays and take advantage of your community's pickup day if available.

The U.S. Fire Administration website has a stunning video from the National Institute of Standards and Training (NIST) of how a dry Christmas tree can act like a blowtorch in your living room and the National Fire Protection Association has side-by-side video showing a dry Christmas tree on fire and a well-watered Christmas tree on fire. The fire in a well–watered tree takes much longer to progress.

Outdoor Decorations

  • Be sure to use only lights rated for outdoor use.
  • Securely anchor outdoor lights and decorations against the wind and storms with insulated holders or hooks.
  • Do not drive nails, staples or tacks through wiring insulation; this can cause a fire.
  • All outdoor electrical decorations should be plugged into a ground-fault circuit interrupter (GFCI). You can buy portable units for outdoor use, or you can have them permanently installed by an electrician.
  • Bring outdoor electrical lights inside after the holidays to prevent hazards and extend their life. Consider replacing old outdoor lights with newer LED lights that are greener and cooler.

For more information on fire safety, contact your local fire department or the Office of the State Fire Marshal at 1-877-9 NO FIRE or www.state.ma.us/dfs and look for Fire Safety Topics.



 


Tags: holiday story,   safety tips,   

If you would like to contribute information on this article, contact us at info@iberkshires.com.

South County Construction Operations

LEE, Mass. — The Massachusetts Department of Transportation (MassDOT) is announcing crews will be conducting daytime and overnight hour guardrail repair, drainage work, bridge repair, and tree trimming operations at various locations and times on I-90 eastbound and westbound during the week of Monday, April 22.
 
Lane closures will be in place during the construction operations and traffic will be able to travel through the work zones.  The schedule for the work and lane closures will be as follows: 
 
Otis/Blandford 
  • Guardrail repair operations will be conducted nightly on I-90 westbound between mile marker 21.0 and mile marker 26.0 from Monday, April 22, through Thursday, April 25, from 7:00 p.m. to 5:30 a.m. the next morning. The work is expected to conclude by 5:30 a.m. on Friday, April 26. 
  • Drainage work will be conducted on I-90 eastbound between mile marker 21.0 to 26.0 from Monday, April 22, through Thursday, April 25, from 7:00 p.m. to 5:30 a.m. the next morning. The work is expected to conclude by 5:30 a.m. on Friday, April 26. 
Blandford
  • Bridge repair work will be conducted nightly on I-90 eastbound and westbound at mile marker 26.4 from Monday, April 22 through Thursday, April 25, from 7:00 p.m. to 5:30 a.m. the next morning. The work is expected to conclude by 5:30 a.m. on Friday, April 26.
Lee
  • Bridge repair work will be conducted daily on I-90 eastbound at mile marker 8.0 from Tuesday, April 23 through Thursday, April 25, from 7:00 a.m. to 3:30 p.m. 
Russell
  • Tree trimming work will be conducted on I-90 westbound between mile marker 33.0 to mile marker 36.0, from Monday, April 22 through Friday, April 26, from 7:00 a.m. to 3:30 p.m. each day. 
 
Appropriate signage, law enforcement details, and messaging will be in place to guide drivers through the work area. 
 
Drivers traveling through the affected areas should expect delays, reduce speed, and use caution.   
 
All scheduled work is weather dependent and subject to change without notice. 
View Full Story

More South Berkshire Stories